POSITAL
Incorrect email or password. Please try again.

DeviceNet

devicenet_encoder

DeviceNet Characteristics

This protocol is mainly used by Allan Bradley / Rockwell. DeviceNet uses the same physical layer as CAN, combined with CIP. The Communications and Information Protocol (CIP) is a communications protocol for transferring automation data between devices. Communication is also done by message telegrams (11 bits of identifier and 8 subsequent bytes).

Controller Area Network

CAN stands for Controller Area Network and was developed by the company Bosch for applications within the automobile area. In the meantime CAN has become increasingly used for industrial applications. CAN is a multi-masterable system, i.e. all users can access the bus at any time as long as it is free. CAN doesn't operate with addresses but with message identifiers.

Bus Access

Access to the bus is performed according to the CSMA/CA principle (carrier sense multiple access with collision avoidance), i.e. each user listens if the bus is free, and if so, is allowed to send messages. If two users attempt to access the bus simultaneously, the one with the highest priority (lowest identifier) receives the permission to send. Users with lower priority interrupt their data transfer and will access the bus when it is free again. Messages can be received by every participant. Controlled by an acceptance filter the participant accepts only messages that are intended for it. POSITAL rotary encoders support two CAN protocols: CANopen and DeviceNet.

Supported Telegram Types

With a POSITAL rotary encoder this number is assigned with by numerical coded turn switches in the connection cap. The function code varies according to the type of message transmitted: PDOs (Process Data Objects) are needed for real time data exchange. Since this messages possess a high priority, the function code and therefore the identifier are low. SDOs (service data objects) are necessary for the bus node configuration (e.g. transfer of device parameters). Because these message telegrams are tranferred acyclicly (usually only while powering up the network), the priority is low.