Incorrect email or password. Please try again.

NEW CANopen MAGNETIC ABSOLUTE ROTARY ENCODER
WITH CONNECTION CAP

ucd_canopen

Intuitive Configuration of CANopen encoders for factory automation

POSITAL’s IXARC magnetic absolute encoders with CANopen interfaces are now available with an optional “connection cap” that makes device configuration and troubleshooting simpler and more intuitive.

  • Robust measurement technology
  • 30% more compact than the optical version
  • Diagnostics via LEDs
  • On site configuration of the address and baud rate via rotary switches
  • Hardware setup of the termination resistor
  • Up to 16 bit Single-Turn, 32 bit for Multi-Turn; battery-free
  • Flexible installation (cable gland, connector), easy in maintenance
  • Separation or combination of power and communication cables
  • High protection degree up to IP 66/67

For previous generation IXARC magnetic encoders with CANopen interfaces, device setup was accomplished by updating software parameters, requiring special tools and expertise. The new connection cap interfaces contain three rotary switches that enable the installer to define the node ID and baud-rate directly with a small screwdriver. There are also diagnostic LEDs on the backside that indicate device and network status. With eight screw terminals inside the cap, the user can easily install cables for power supply and bus-in bus-out. A slide switch can be set to activate a termination resistor when the device is located at the end of the network, reducing installation costs.

ucd_canopen_cap

Excellent Choice for a Variety of Industries

IXARC magnetic absolute encoders with CANopen interfaces are ideal for a wide range of motion control and factory automation applications. Compared to optical encoders, they are almost 30% more compact, with superior resistance to shock and vibration loads. Available IP 66/67 protection makes these devices suitable for harsh environmental conditions. Single- and multi-turn models are available; for multi-turn versions, the rotation counter is self-powered, with no need for backup batteries and a measurement range of four billion revolutions (32 bits). A variety of connection cap options are available, including cable glands for cables of various lengths and M12 connectors for use with pre-assembled cables. Connection caps with two or three connectors make it possible to connect multiple devices in series (daisy chain), without T-couplers.

Read More about the CANopen Interface

construction_machine_3 standing_crane_1 ship elevator_4

Easily Find the Right IXARC Sensor for Your Application

product_finder_continous_textjpg